Vacuum Pad
Vacuum Cylinder
Only supplying compressed air, work-piece will be held and raised under suction.
Advantages
Only supplying compressed air, work-piece will be held and raised under suction.
Vacuum pad equipped with vacuum generator and cylinder.
By simply supplying compressed air, the work-piece is sucked and the slide shaft is lifted by vacuum.
Wide selection of pad sizes and materials.
Pad size(mm):φ4, φ6, φ8, φ10, φ15, φ20, φ30, φ40
Pad material:Nitrile, Silicone, Fluorosilicone rubber
Port size
Pad size(mm)
| φ4, φ6, φ8, φ10, φ15, φ20, φ30, φ40 |
|---|
Port tube dia.
| Push-in fitting(mm) | φ4, φ6 |
|---|---|
| Barb fitting (Tube O.D.xI.D.)(mm) | φ4xφ2.5, φ6xφ4 |
Construction
Ordering Information
Detailed Safety Instructions
Warning
1.Do not apply any lateral force to the ejector or shaft of this product. It may cause damage to the product.
2.When mounting the vacuum cylinder by using bulkhead to the actual equipment, use an appropriate tool and tighten it with a tightening torque of 2 to 3 Nm, and make sure that there is no loosening. Also, over-tightening will cause deformation of the spring loaded holder, which will result in malfunction of the shaft.
Caution
1.Note that the silencer element cannot be replaced.
2.Refer to "Common Safety Instructions for Vacuum Series" and "Common Safety Instructions for Vacuum Pads" for handling the ejector and vacuum pads.
3.When selecting, be sure to understand the following details of cylinder (lifting) thrust, and perform a suction test on the actual operating condition.
Inquiries about this product
It is also possible to suggest products suitable for various conditions such as applications and functions. Please feel free to contact us or visit the nearest sales office.
The following are frequently asked questions. Please check before making inquiries.
